BMW i3 Engine warning light on & range extender not starting – only battery power available

Recently in the workshop, this BMW i3 which had a permanent engine warning light on the dash, then when driven another warning light on the I-drive would appear for ranger extender not available, only high voltage battery available.

The range extender on this i3 model is basically a two cylinder motorbike engine which intermittently cuts in & out when required to provide extra charge to the high voltage battery, to ‘extend the range’ of the battery/ vehicle.For simplicity in this post we are now going to call the range extender, the engine!

We road tested the vehicle to confirm the fault. Once in the workshop connected to our BMW diagnostic tool which showed x2 related faults to the range extender. Crankshaft position sensor, signal not plausible & oil pressure switch not plausible.

First we checked the engine oil level to make sure there was oil present in the engine, which there was! Next step is to attempt to run the engine to check if the crank sensor & oil pressure sensor will display any plausible readings. There is a procedure on the BMW diagnostic system which allows us to start the engine.
Once pressed the engine started, much to our surprise as on most conventional engines a crank sensor fault can prevent an engine from starting/ running from the engine ecu not knowing its position to activate ignition & fuel systems in the right order.

With the engine running we inspected the live data, engine speed – rpm was displayed correctly & oil pressure was good. On some engines, the ecu can use the camshaft position sensor instead, should the crank position sensor fail. As a fail safe to keep the engine running.

Ok, so was this fault a one off, as everything is checking out correctly at the moment? Next we cleared the fault memory, road tested the vehicle again. No warning lights had returned on but the engine did not cut in (then out) as expected. Once back on the BMW diag tool, the crankshaft position sensor implausible signal fault code has returned.

Next step is to check the signal from the crank sensor, to see if the correct signal is being produced. With the wiring diagram & wiring connections located at the engine ecu. Power supply & earth to the sensor are present & correct. We then started the engine & measured the output signal waveform with an oscilloscope. No waveform present on the signal line, just a flat 5 volts on the line, meaning the crank sensor is defective or the wire between the sensor to ecu is broken. Unfortunately the location of the crank sensor is not easily accessible on this model, sandwiched between the engine to the rear bulkhead. The repair instructions state the engine has to be removed to access the sensor to replace it meaning checking the wiring between the sensor to the ecu is not possible without removing the engine.

The decision was taken to replace the crank sensor. With the assistance of our excellent apprentice with long arms and small hands. He carried out contortion to replace the crank sensor without removing the engine, saving the owner a pretty penny!! Once the sensor was replaced, we checked the signal waveform again with the engine running which now shows the correct waveform
Cleared all fault codes. Road tested the vehicle whilst inspecting the live data to make sure the engine cuts in & out when required, which it did!

Fault rectified, money saved!
Burch Motor Works

You may also like