This vehicle arrived with us with the description above, which sounded quite far fetched, could it be related?
First we carried out a short road test, the drivetrain warning light was on from the first start but drove all ok.
With the vehicle in the workshop we carried out a full diagnostic test/ scan.
Engine related fault codes for the electric vacuum pump, lin bus communication, engine emergency running & high voltage power management.
By studying the faults stored we notice most are currently present therefore we should be able to test & find the faults in the workshop.
First we carried out a test on the electric vacuum pump.
On a regular petrol or diesel engine’d vehicle, vacuum is created by the engine internally or a pump mechanically driven by the engine camshaft, for braking servo assistance.
With this being a hybrid, the engine is not constantly running, therefore a separate electric vacuum pump is required to provide vacuum to give braking servo assistance.
We activated the vacuum pump via the diagnostics which could be heard working correctly. The location of the pump is in the front left corner behind the front bumper, which is where the pheasant impacted the front bumper grille.
Upon removal of the front left wheel & arch, we did indeed find the cause of the problem. The connection from the vacuum pump to pipe work has snapped off…. From, you guessed it the impact damage from the pheasant.
So yes, the faults are related!
The vehicle has sensors fitted to detect drops in pressures. With the pipe work broken & lack of vacuum produced from the pump, the sensors notice this, starting the combustion engine to provide vacuum instead, along with displaying the engine drivetrain warning light on to notify the driver of a fault!
With a new vacuum pump & bumper grille fitted this fault was rectified.
However we still had a static/ present fault for the LIN bus communication to coolant pump 2 on the low temperature circuit.
The vehicle is fitted with two cooling systems. The high temperature system for the combustion engine, main radiator & air conditioning system condenser.
The low temperature system for the turbochargers & charge air cooler.
The x2 electric coolant pumps are located behind the radiator between the engine at the base, accessed under the car.
Using the diagnostics we checked the activation state of both coolant pumps. Coolant pump 1 was activated at various speeds correctly. Coolant pump 2 speed was at maximum speed which could not be adjusted, as expected with the fault stored.
Once at the pumps, using an oscilloscope we checked the power & ground to the pumps, which was ok. Next checking the lin bus signal. The signal should look similar to square wave, read near 12 volts, with the communication messages dropping to ground making the average around 9-10 volts.
On coolant pump 1 as expected the signal waveform was correct. But on coolant pump 2 the signal was incorrect with a jagged pattern, proving the fault code description was right.
Using a wiring diagram we worked backwards from the coolant pump 2 tracing the wiring loom. The loom went along the front left wheel arch to under the bonnet. Near the area of the pheasant damage, so could this fault also be related?
We stripped the wiring loom insulation back until we found the damaged & broken lin bus wire in question! (Blue with a white trace). Upon further inspection there has been previous wiring repair in this area. Strangely no connection to the pheasant damage, just this wire repair was missed or broken further since a previous repair!
With the wire repaired correctly, the lin bus signal at coolant pump 2 was now correct and fault code could be cleared. Wiring insulated, parts refitted. The car was road tested which now drives correctly under battery power with no warning lights present.
Different and interesting faults on this vehicle. We suspect the pheasant ultimately came off worse than the customers wallet though!
Burch Motor Works