πŸ”§ MINI Paceman recovered as a non-start. But this was not a standard garage repair! πŸ”§

This MINI Paceman arrived with us after being recovered as a complete non-starter. The RAC had previously attended the vehicle and replaced the starter motor, however the fault remained and the vehicle still refused to start.
After pushing the vehicle into the workshop, we connected our diagnostic equipment and quickly found faults relating to Terminal 50 within the CAS (Car Access System). Further testing revealed there was no communication from the DME during the starting process.
Initial checks confirmed the 40-amp CAS supply fuse was intact and receiving battery voltage. Testing of the starter motor exciter circuit showed the CAS was initially providing a 12-volt start command, however the voltage immediately collapsed under load.
At this stage the fault could have been caused by either a wiring issue between the CAS and starter motor or an internal fault within the CAS control unit itself.
To prove the wiring and starter circuit, we disconnected the starter exciter wire and manually supplied battery voltage directly to the starter motor. The starter engaged immediately and the engine started correctly, confirming the starter motor, battery feeds, earths and associated wiring were all functioning as intended.
The next challenge was gaining access to the CAS module itself. On this model the CAS unit is hidden behind the dashboard, requiring removal of the dashboard assembly and steering column before further testing could be carried out.
With access gained, we tested the CAS control unit directly. Battery voltage remained stable at the CAS power supply, however the output to the starter circuit again dropped instantly under load. This confirmed the control unit was receiving correct power but was unable to deliver current to the starter circuit.
The CAS unit was then dismantled for internal inspection, where we discovered burnt terminals and a failed relay on the circuit board, confirming an internal CAS failure.
Rather than replacing the CAS unit with an expensive new part from the main dealership, we sourced a quality used β€œgreen” CAS module, saving the owner hundreds of pounds. Using specialist equipment, we successfully cloned all vehicle data, immobiliser information and coding from the original unit onto the replacement module.
The replacement CAS was then installed, programmed and tested.
Another vehicle accurately diagnosed, repaired and returned to the road without unnecessary parts replacement.
At Burch Motor Works, diagnosis comes first. Finding the fault properly often saves our customers a significant amount of money compared to simply replacing parts and hoping for the best.
πŸ”§ Burch Motor Works πŸ”§

You may also like